Touch-Less V2

Bilt Hamber Touch-Less V2 - Powerful Pre-Wash Snow Foam

A powerful contactless pre-wash that safely removes dirt before hand washing, reducing swirl marks.

Key Features & Benefits:

✅ Highly Concentrated – Effective even at high dilution ratios.
✅ pH Neutral on Dilution – Safe for wax, sealants & coatings.
✅ Strong Dirt Removal – Lifts grime and traffic film without agitation.
✅ Foam Cannon Compatible – Thick, clinging foam for extended dwell time.

How to Use:

1. Apply using a foam cannon or sprayer.
2. Allow it to dwell for 3–5 minutes (do not let it dry).
3. Rinse thoroughly with a pressure washer.

Recommended Dilution Ratios:

• Foam Sprayer: 1:50 to 1:200
• Foam Lance/Cannon: 1:5 to 1:20 or follow guide below for accurate calculation.

The minimum recommended dilution rate should be 0.5% PIR (Panel Impact Ratio) and up to 2% depending on dirt level on your vehicles. Where application is through trigger spray or pump spray, the dilution calculation is easy to achieve, however, for application with pressure equipment it is essential to determine the amount of water being delivered to the equipment reservoir. It it recommended to keep your car dry (no prior rinsing) when applying Touch-Less V2.

Step 1

Fill your foam cannon up to 1L capacity with plain water. Turn the feed to full. Take your wash bucket and discharge the lance into this, watching the foam cannon bottle until empty. Once empty, stop and measure volume of water collected.

Step 2

The following calculations will achieve 2% dilution; Measure the total amount collected and multiply this number by 0.02 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of Touch-Less V2 to use. Eg. if water collected is measured at 15L for 2% PIR, Touch-Less required = 15000mL x 0.02 = 300ml.

Step 3

Add the calculated amount from Step 2 to the foam cannon and top up to the rest full with water and shake.

Step 4

Apply touchless to entire vehicle or panel by panel. Allow to soak for 1-5 minutes (but never allow to dry). Power-wash off.

It is not necessary to use all diluted touch-less in one wash. One litre of diluted product should last 4-5 washes. Apply to cool panels in shaded conditions. Do not allow this product to dry in use. Keep the bottle neck and lid clean.